About Arvada HVAC Pros

We are a heating and cooling crew based in Arvada, at 6711 W 58th Pl, Arvada, CO 80003. We fix and fit furnaces, air conditioners, heat pumps, boilers, and ductless systems for homes across the northwest metro.

📞 Talk to an HVAC Specialist: (983) 955-0252

Frequently Asked Questions

How fast can you come out?

Most repair calls are booked the same day. Winter no-heat calls go first.

Do you quote before you start?

Always. You get the fault and the full price before any part goes in. The quote is the price.

What does a repair cost?

Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.

Do you service boilers and radiators?

Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.

Can a heat pump work in Colorado winters?

Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.

Do you clean ducts?

Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.

What Does My HVAC Project Cost?

HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.

HVAC Repair

Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.

AC Installation & Replacement

A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.

Heat Pumps — Repair & Installation

Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.

Ductless Mini-Split Installation

A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.

What Moves the Price

  • The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
  • Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
  • Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
  • Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.

Estimate Your Project

1 · Pick your project

The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Aerial view of a rooftop row of condenser fan units

Our rule is simple. Find the fault first. Quote the full price. Then fix it once. If a repair is the smart call, we say so. If a system is at the end of its life, we show you the math. You decide. No one here works on a sales quota.

Arvada sits at about 5,300 feet. Thin air is part of every job. Furnaces need gas pressure and air flow set for altitude. AC sizing changes too. You learn these details by working here. A west-facing room in Lakewood, for one, needs more cooling than the chart says.

We serve Arvada first, then Lakewood, Wheat Ridge, Golden, Broomfield, Westminster, Thornton, and the rest of our service areas. Call us at (983) 955-0252.

What We Work On

The full list runs to 20 services. Heating: furnace repair and installation, boiler repair and replacement, and heat pumps. Cooling: AC repair, AC installation and replacement, and ductless mini-splits. Around the system: duct repair and cleaning, indoor air quality, thermostats, zoning, and tune-ups. We also run emergency repair when a system quits at the wrong hour, full HVAC replacement when both sides of a system reach the end together, and commercial installation, repair, and maintenance for local businesses. We service the major furnace, AC, boiler, and mini-split brands found in metro homes — tell us the brand and model when you book and we bring the right parts.

How a Visit Works

You call or send the form. We ask what the system is doing, book a window, and show up with the common parts on the truck. We test, find the fault, and quote the full price. You approve it, we fix it, and we run the system through a full cycle before we call it done. Most repair calls are booked the same day, and no-heat calls in winter go first. On installs, a deposit books the work and the balance is due when the job tests right. Think of it like a good mechanic: find the fault first, fix it once, and show your work.

Request Service

Prefer to talk? Call (983) 955-0252.

📞 (983) 955-0252