Results & Recent Jobs
Every job below is shown in full — scope, materials, price, and time — with nothing held back behind a slider or a tab.
📞 Talk to an HVAC Specialist: (983) 955-0252Frequently Asked Questions
How fast can you come out?
Most repair calls are booked the same day. Winter no-heat calls go first.
Do you quote before you start?
Always. You get the fault and the full price before any part goes in. The quote is the price.
What does a repair cost?
Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.
Do you service boilers and radiators?
Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.
Can a heat pump work in Colorado winters?
Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.
Do you clean ducts?
Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.
What Does My HVAC Project Cost?
HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.
HVAC Repair
Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.
AC Installation & Replacement
A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.
Heat Pumps — Repair & Installation
Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.
Ductless Mini-Split Installation
A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.
What Moves the Price
- The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
- Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
- Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
- Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.
Estimate Your Project
The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.
Permit, haul-away, PVC venting on the 96% tier, and altitude setup are in every price.
Priced on existing ducts, matched condenser and coil. New duct runs are priced at the visit.
Dual-fuel keeps your furnace as backup heat — the heat pump carries the year, the furnace takes the coldest nights.
Most single-zone installs are done in one day. Cold-climate units are the standard spec here.
Fall for heating, spring for cooling. A worn part found on the visit is quoted in full before any work starts.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Arvada HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the system. Photos of the nameplate, the furnace cabinet, and the outdoor unit help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 955-0252.
Heat Pump Installation
For Ellen, the math was simple: steep gas bills plus an AC at end of life equals one new system, not two. The cold-climate unit she picked is rated to -13°F, pairs with a new air handler, and hands the coldest nights back to her existing furnace. Installed over two days in her 2,000 sq ft Arvada home.
- Service performed
- Heat Pump Installation in Arvada.
- Scope of work
- Cold-climate heat pump set with a new air handler; furnace kept as backup heat.
- Materials / products used
- Cold-climate inverter heat pump, rated to -13°F.
- Size
- 3-ton system for a 2,000 sq ft home.
- Final price
- $11,075.
- Cost per sq ft
- About $5.54 per sq ft of home served.
- Turnaround / duration
- Two days.
- Payment terms / financing
- Deposit to book; balance due after both heat and cool tests pass.
- Problem found
- Gas bills topped $300 a month and the old AC was at end of life.
- Solution delivered
- Dual-fuel heat pump; furnace now runs only on the coldest nights.
- Homeowner first name
- Ellen.
- Homeowner city / neighborhood
- Arvada, CO.
- Homeowner situation (in their own terms)
- My AC was dying and my gas bills were over $300 a month in winter. Replacing both separately made no sense.
- Outcome and homeowner reaction
- The heat pump now does the year's work with the furnace as a safety net. Ellen's first winter bill after the swap came in under half the old ones.
Boiler Installation & Replacement
The boiler Chris replaced was not broken — it was just old, hungry, and uneven, the way 28-year-old cast iron gets. His new condensing unit sips fuel on mild days thanks to an outdoor reset control, and still keeps all ten radiators warm when the cold sets in. Piping and controls were redone with it over two days.
- Service performed
- Boiler Installation & Replacement in Arvada.
- Scope of work
- Old cast-iron boiler out; condensing boiler in with new piping and controls.
- Materials / products used
- 95% AFUE condensing gas boiler.
- Size
- 110,000 BTU unit serving 10 radiators.
- Final price
- $9,525.
- Cost per sq ft
- Not used for this example.
- Turnaround / duration
- Two days.
- Payment terms / financing
- Deposit to book; balance due after the room-by-room heat test.
- Problem found
- 28-year-old boiler used more fuel each year and heated unevenly.
- Solution delivered
- Condensing boiler with outdoor reset control; fuel use dropped and heat evened out.
- Homeowner first name
- Chris.
- Homeowner city / neighborhood
- Arvada, CO.
- Homeowner situation (in their own terms)
- It heated, but it heated expensively and unevenly. I wanted the replacement to fix the bills, not just the boiler.
- Outcome and homeowner reaction
- The condensing boiler evened out the house and trimmed the fuel bill in its first season. Chris kept the old unit's data plate as a souvenir of a long career.
Commercial HVAC Repair & Maintenance
A retail space in Arvada lost its rooftop unit on a Friday with a hot weekend coming — the kind of call that decides whether Saturday makes money. The belt and contactor went on by evening, the coil got cleaned while the crew was up there, and the shop opened cool on Saturday.
- Service performed
- Commercial HVAC Repair & Maintenance in Arvada.
- Scope of work
- Rooftop unit repair: blower belt and contactor swapped, coil cleaned, full run test.
- Materials / products used
- OEM belt and contactor set.
- Size
- 5-ton rooftop unit on a 4,000 sq ft retail space.
- Final price
- $189.
- Cost per sq ft
- Not used for repair work.
- Turnaround / duration
- Fixed before the shop opened next day.
- Payment terms / financing
- Full price quoted before work; invoice terms for plan accounts.
- Problem found
- Rooftop unit quit on a Friday afternoon with a hot weekend ahead.
- Solution delivered
- Belt and contactor swapped Friday evening; shop opened cool on Saturday.
- Customer first name
- Hannah.
- Customer city / neighborhood
- Arvada, CO.
- Customer situation (in their own terms)
- The unit quit Friday afternoon with a hot weekend ahead. For a shop, Saturday is not a day you can hand back.
- Outcome and customer reaction
- The Saturday opening happened at full cooling, on a $189 repair. Hannah, who manages the space, said the weekend's sales never knew anything had happened.
Your job could be next
Prefer to talk? Call (983) 955-0252.