HVAC Services in Commerce City, CO

Arvada HVAC Pros provides heating and cooling services in Commerce City, with most repair calls booked the same day.

Commerce City runs from the old refinery-side blocks to the new Reunion neighborhoods in the north. Reunion and Buffalo Run homes are newer but big, with long duct runs. Older blocks near the Platte have small furnaces in tight closets.

In the Reunion area the problem is distance: long duct runs lose air before it reaches the far bedrooms. We test flow at the far registers first. In the older blocks, the work is smaller: closet furnaces, window-unit swaps, and ductless heads for rooms that never had ducts.

📞 Talk to an HVAC Specialist: (983) 955-0252

Frequently Asked Questions

How fast can you come out?

Most repair calls are booked the same day. Winter no-heat calls go first.

Do you quote before you start?

Always. You get the fault and the full price before any part goes in. The quote is the price.

What does a repair cost?

Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.

Do you service boilers and radiators?

Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.

Can a heat pump work in Colorado winters?

Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.

Do you clean ducts?

Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.

What Does My HVAC Project Cost?

HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.

HVAC Repair

Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.

AC Installation & Replacement

A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.

Heat Pumps — Repair & Installation

Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.

Ductless Mini-Split Installation

A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.

What Moves the Price

  • The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
  • Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
  • Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
  • Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.

Estimate Your Project

1 · Pick your project

The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Projects Completed in Commerce City

Boiler Repair — a Commerce City job

Frank's Commerce City boiler kept tripping its relief valve and the gauge needle lived in the red zone by mid-morning. The expansion tank had waterlogged and the automatic air vent was crusted shut, so pressure had nowhere to go. Both parts were swapped and the system was re-pressurized cold.

Service performed
Boiler Repair in Commerce City.
Scope of work
Expansion tank and automatic air vent swap, full system re-pressurization and a hot pressure test.
Materials / products used
Steel expansion tank and brass automatic air vent.
Size
90,000 BTU boiler serving 7 radiators.
Final price
$430.
Cost per sq ft
Not used for repair work.
Turnaround / duration
Same day, about 2 hours.
Payment terms / financing
Price set before parts were pulled; balance due after the hot pressure test held steady.
Problem found
Waterlogged expansion tank sent boiler pressure into the red and tripped the relief valve.
Solution delivered
New tank and vent fitted; pressure now holds in range cold and hot, and the relief valve stays shut.
Homeowner first name
Frank.
Homeowner city / neighborhood
Commerce City, CO.
Homeowner situation (in their own terms)
Every morning the gauge was in the red and there was a puddle by the relief pipe. I knew pressure problems do not fix themselves.
Outcome and homeowner reaction
Frank's gauge now sits mid-range through a full firing. He said the dry floor under the relief pipe is the proof he checks every morning.

Boiler Installation & Replacement — a Commerce City job

Helen's Commerce City bungalow ran a boiler from the year the house was built into the record books — a standard cast-iron unit was the right replacement, no condensing upgrade, matched to her eight radiators. The old unit came out and the new one went in over two days with refreshed near-boiler piping.

Service performed
Boiler Installation & Replacement in Commerce City.
Scope of work
Old boiler out; new standard cast-iron boiler in with refreshed near-boiler piping and controls.
Materials / products used
Standard cast-iron gas boiler, 83% AFUE.
Size
100,000 BTU unit serving 8 radiators.
Final price
$7,860.
Cost per sq ft
Priced per boiler, not per square foot.
Turnaround / duration
Two days.
Payment terms / financing
Deposit at booking; balance after every radiator was tested hot, room by room.
Problem found
Original boiler at end of life, with rising fuel use and two radiators heating unevenly.
Solution delivered
New cast-iron boiler sized to the radiator count; all eight radiators now heat on one call.
Homeowner first name
Helen.
Homeowner city / neighborhood
Commerce City, CO.
Homeowner situation (in their own terms)
I wanted the same kind of boiler that lasted forty years, just new. No apps, no experiments — hot water in iron pipes, like the house was built for.
Outcome and homeowner reaction
Helen's two stubborn radiators came up with the rest on test day. She said the new unit firing quietly, without the old one's kettle rumble, still surprises her.

Ductless Mini-Split Installation — a Commerce City job

Victor's Commerce City garage workshop had no heat and no cooling, and a window unit was not going to fix January. A single-zone mini-split — one 18,000 BTU wall head on a cold-climate outdoor unit — went up in a day and now holds the shop at working temperature year-round.

Service performed
Ductless Mini-Split Installation in Commerce City.
Scope of work
Single-zone mini-split set: one wall head in the workshop on a cold-climate outdoor unit.
Materials / products used
Cold-climate inverter mini-split, single 18,000 BTU wall head.
Size
One zone, 620 sq ft workshop served.
Final price
$4,620.
Cost per sq ft
About $7.45 per sq ft of space served.
Turnaround / duration
One day.
Payment terms / financing
Deposit to book the day; balance due after the head tested in heat and cool.
Problem found
Unheated, uncooled garage workshop; winter projects stalled and summer ones ended by noon.
Solution delivered
Single ductless zone now holds the shop at a steady working temperature in both seasons.
Homeowner first name
Victor.
Homeowner city / neighborhood
Commerce City, CO.
Homeowner situation (in their own terms)
I build furniture out there. Below 50 degrees the glue and I both quit, and July afternoons were worse.
Outcome and homeowner reaction
Victor kept the shop at 68 through a January cold snap without a space heater. He said the first winter project finished on schedule is what the unit really bought.

Growth is the story in Commerce City. New homes come with builder-grade setups that often were never balanced or taught to the owner. A first-year check — air flow, charge, stat setup — pays off more here than in older areas.

Services in Commerce City

Boiler Repair · Boiler Installation & Replacement · Ductless Mini-Split Installation — and the rest on the Services page. Local note: systems here are set for altitude, at about 5,300 feet, like every job we run in the metro.

Not your town? See the full Service Areas list.

Request Service in Commerce City

Call (983) 955-0252 or send the form on the Contact page. Tell us the city and what the system is doing, and we will book the right visit.

📞 (983) 955-0252