HVAC Services in Ken Caryl, CO

Arvada HVAC Pros provides heating and cooling services in Ken Caryl, with most repair calls booked the same day.

Ken Caryl Ranch spreads through the hogback valleys in the southwest metro, with trails in every direction. Ken Caryl homes are mostly 1980s and 90s builds. Their furnaces and AC units are hitting the age where repair-versus-replace is a yearly talk.

Ken Caryl homes were built in waves, and whole streets hit equipment age at once. We see many first-swap talks here: original furnace, original AC, both tired. Our job is the honest math — repair cost, unit age, and gas use, side by side.

📞 Talk to an HVAC Specialist: (983) 955-0252

Frequently Asked Questions

How fast can you come out?

Most repair calls are booked the same day. Winter no-heat calls go first.

Do you quote before you start?

Always. You get the fault and the full price before any part goes in. The quote is the price.

What does a repair cost?

Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.

Do you service boilers and radiators?

Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.

Can a heat pump work in Colorado winters?

Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.

Do you clean ducts?

Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.

What Does My HVAC Project Cost?

HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.

HVAC Repair

Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.

AC Installation & Replacement

A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.

Heat Pumps — Repair & Installation

Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.

Ductless Mini-Split Installation

A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.

What Moves the Price

  • The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
  • Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
  • Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
  • Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.

Estimate Your Project

1 · Pick your project

The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Projects Completed in Ken Caryl

AC Repair — a Ken Caryl job

Bonnie's Ken Caryl condenser started with a scream on the summer's first 90-degree day — the outdoor fan seized mid-run and the compressor tripped on heat within the hour. The fan motor had cooked its bearings. A new motor and blade, plus a capacitor for insurance, had the unit cooling again by evening.

Service performed
AC Repair in Ken Caryl.
Scope of work
Condenser fan motor and blade swap, capacitor replaced, and a full cooling run test.
Materials / products used
OEM condenser fan motor, blade, and run capacitor.
Size
3.5-ton condenser, 2,260 sq ft home.
Final price
$520.
Cost per sq ft
Not used for repair work.
Turnaround / duration
Same day, about 2 hours.
Payment terms / financing
Quoted in full before the motor was pulled; balance due when the house started dropping.
Problem found
Condenser fan motor seized on a 90-degree day; the compressor tripped on heat within the hour.
Solution delivered
New fan motor fitted; the unit now runs a full cooling cycle without a thermal trip.
Homeowner first name
Bonnie.
Homeowner city / neighborhood
Ken Caryl, CO.
Homeowner situation (in their own terms)
A screaming fan, then silence, then a house climbing a degree every twenty minutes. You do not need a gauge to know that story.
Outcome and homeowner reaction
Bonnie's house dropped six degrees before the crew left. She said the quiet fan — no scream at start-up — is how she knows it is fixed every morning.

AC Installation & Replacement — a Ken Caryl job

Russell's Ken Caryl home faced the foothills with a wall of west glass, and his builders-grade AC had been undersized since the day the house sold. He replaced it with a properly load-checked standard-efficiency 2.5-ton matched set, and the great room finally cools like the rest of the house.

Service performed
AC Installation & Replacement in Ken Caryl.
Scope of work
Undersized unit out; load-checked 2.5-ton standard-efficiency condenser and matched coil in.
Materials / products used
15 SEER2 condenser and matched evaporator coil.
Size
2.5-ton system for a 1,940 sq ft home.
Final price
$6,150.
Cost per sq ft
About $3.17 per sq ft of home served.
Turnaround / duration
One day.
Payment terms / financing
Half down at booking; the remainder after the great-room temperature test.
Problem found
Undersized builders-grade AC never cooled the west-facing great room below 79.
Solution delivered
Load-checked matched system; the great room now holds 73 on west-sun afternoons.
Homeowner first name
Russell.
Homeowner city / neighborhood
Ken Caryl, CO.
Homeowner situation (in their own terms)
The builder put in the cheapest box that passed inspection and it showed every July. I wanted the math done this time, not the guess.
Outcome and homeowner reaction
Russell's great room held 73 through a sunny afternoon for the first time since he bought the house. He said the load check printout is taped inside the furnace door now.

Heat Pump Installation — a Ken Caryl job

Vera's Ken Caryl home had electric baseboards in the addition and a gas furnace everywhere else — two bills, two systems, one cold shoulder season. A ducted air-source heat pump tied into the main ducts now carries heating and cooling for the whole 2,180 sq ft, with the furnace as deep-winter backup.

Service performed
Heat Pump Installation in Ken Caryl.
Scope of work
Ducted air-source heat pump set with a new air handler; existing furnace kept as backup heat.
Materials / products used
Ducted inverter heat pump with a variable-speed air handler.
Size
3-ton system for a 2,180 sq ft home.
Final price
$10,360.
Cost per sq ft
About $4.75 per sq ft of home served.
Turnaround / duration
Two days.
Payment terms / financing
Deposit to schedule; balance after both modes tested at the thermostat.
Problem found
Split heating setup — baseboards in the addition, furnace elsewhere — with two sets of bills.
Solution delivered
One ducted heat pump now heats and cools the whole home; baseboards stay off.
Homeowner first name
Vera.
Homeowner city / neighborhood
Ken Caryl, CO.
Homeowner situation (in their own terms)
Half my house was on one system and half on another, and the shoulder seasons belonged to neither. I wanted one machine with one bill.
Outcome and homeowner reaction
Vera's addition finally matches the rest of the house in October weather. She said retiring the baseboard heaters freed a whole wall of her studio.

The hogback setting gives Ken Caryl homes strong sun splits: west rooms bake, north rooms lag. Zoning and duct balance come up on most calls. We measure room by room rather than guessing from the thermostat wall.

Services in Ken Caryl

AC Repair · AC Installation & Replacement · Heat Pump Installation — and the rest on the Services page. Local note: systems here are set for altitude, at about 5,300 feet, like every job we run in the metro.

Not your town? See the full Service Areas list.

Request Service in Ken Caryl

Call (983) 955-0252 or send the form on the Contact page. Tell us the city and what the system is doing, and we will book the right visit.

📞 (983) 955-0252