HVAC Services in Broomfield, CO
Arvada HVAC Pros provides heating and cooling services in Broomfield, with most repair calls booked the same day.
Broomfield spreads across the US-36 corridor between Denver and Boulder, from old town blocks to the FlatIron Crossing area. Broomfield homes range from 1970s builds to new subdivisions. Two-story plans here fight the classic split: hot up, cold down.
Broomfield calls split two ways. Old town homes need honest repair work on aging furnaces. Newer subdivisions need zoning, air balance, and warranty-age upkeep done right. We ask which part of town you are in when you book, since the kit we bring differs.
Frequently Asked Questions
How fast can you come out?
Most repair calls are booked the same day. Winter no-heat calls go first.
Do you quote before you start?
Always. You get the fault and the full price before any part goes in. The quote is the price.
What does a repair cost?
Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.
Do you service boilers and radiators?
Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.
Can a heat pump work in Colorado winters?
Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.
Do you clean ducts?
Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.
What Does My HVAC Project Cost?
HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.
HVAC Repair
Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.
AC Installation & Replacement
A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.
Heat Pumps — Repair & Installation
Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.
Ductless Mini-Split Installation
A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.
What Moves the Price
- The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
- Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
- Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
- Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.
Estimate Your Project
The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.
Permit, haul-away, PVC venting on the 96% tier, and altitude setup are in every price.
Priced on existing ducts, matched condenser and coil. New duct runs are priced at the visit.
Dual-fuel keeps your furnace as backup heat — the heat pump carries the year, the furnace takes the coldest nights.
Most single-zone installs are done in one day. Cold-climate units are the standard spec here.
Fall for heating, spring for cooling. A worn part found on the visit is quoted in full before any work starts.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Arvada HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the system. Photos of the nameplate, the furnace cabinet, and the outdoor unit help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 955-0252.
Projects Completed in Broomfield
AC Installation & Replacement — a Broomfield job
Kevin's Broomfield ranch had a 15-year-old condenser that rattled, sweated, and still left the west bedrooms warm by bedtime. He skipped the high-efficiency tier and picked a standard 15 SEER2 matched set, 2.5 tons for his 1,880 sq ft, swapped in one day with the old pad replaced.
- Service performed
- AC Installation & Replacement in Broomfield.
- Scope of work
- Old 2.5-ton unit out; new standard-efficiency condenser and matched indoor coil in on a new pad.
- Materials / products used
- Standard-efficiency 15 SEER2 condenser and matched coil.
- Size
- 2.5-ton system for a 1,880 sq ft home.
- Final price
- $6,720.
- Cost per sq ft
- About $3.57 per sq ft of home served.
- Turnaround / duration
- One day.
- Payment terms / financing
- Deposit on booking; balance collected after the cooling test and walkthrough.
- Problem found
- 15-year-old condenser rattled and left the west bedrooms warm at bedtime.
- Solution delivered
- New matched standard system; every bedroom now reaches set point before dark.
- Homeowner first name
- Kevin.
- Homeowner city / neighborhood
- Broomfield, CO.
- Homeowner situation (in their own terms)
- I did not need the fanciest box on the lot. I needed the back bedrooms cool by the time the kids go to bed.
- Outcome and homeowner reaction
- The west bedrooms hit set point by dinner on the first hot day. Kevin said the new pad alone ended the rattle he had listened to for three summers.
Heat Pump Installation — a Broomfield job
Sandra's Broomfield two-story needed cooling first and foremost — her furnace was mid-life and staying — so she chose a ducted air-source heat pump that takes over cooling and handles heat down into the 30s before the furnace steps in. The 2.5-ton system went in over two days with a new air handler.
- Service performed
- Heat Pump Installation in Broomfield.
- Scope of work
- Ducted air-source heat pump set with a new air handler; existing furnace kept for the coldest stretch.
- Materials / products used
- Ducted inverter heat pump and matching air handler.
- Size
- 2.5-ton system for a 1,760 sq ft home.
- Final price
- $9,240.
- Cost per sq ft
- About $5.25 per sq ft of home served.
- Turnaround / duration
- Two days.
- Payment terms / financing
- Deposit to schedule; final payment after heat and cool modes both tested.
- Problem found
- No efficient cooling in the house and shoulder-season heating costs higher than they should be.
- Solution delivered
- Ducted heat pump carries cooling and mild-weather heat; the furnace only fires in deep cold now.
- Homeowner first name
- Sandra.
- Homeowner city / neighborhood
- Broomfield, CO.
- Homeowner situation (in their own terms)
- My furnace had years left, so replacing everything felt wasteful. I wanted one unit that cools properly and helps with heat when it can.
- Outcome and homeowner reaction
- Sandra's spring power bill came in well under the old spring bills. She said the house cooling evenly, top floor included, was the change she noticed first.
Heat Pump Repair — a Broomfield job
Jason's Broomfield heat pump heated the downstairs and gave up on the bedrooms — the air handler blew weak and lukewarm whenever the call ran long. Testing found the indoor blower motor dropping speed as it heated up. A new motor and a capacitor brought full airflow back in one visit.
- Service performed
- Heat Pump Repair in Broomfield.
- Scope of work
- Air-handler blower motor and capacitor swap, with an airflow test at every register.
- Materials / products used
- OEM variable-speed blower motor and run capacitor.
- Size
- 3-ton heat pump, 1,920 sq ft home.
- Final price
- $475.
- Cost per sq ft
- Not used for repair work.
- Turnaround / duration
- Same day, about 2 hours.
- Payment terms / financing
- Full quote given before the motor came out; paid when register airflow tested even.
- Problem found
- Indoor blower motor lost speed as it warmed; upstairs registers blew weak and lukewarm.
- Solution delivered
- New blower motor fitted; airflow at the bedroom registers now matches the main floor.
- Homeowner first name
- Jason.
- Homeowner city / neighborhood
- Broomfield, CO.
- Homeowner situation (in their own terms)
- Downstairs was fine and the bedrooms were a different season. Long calls just made it worse, which pointed at the blower, not the heat pump itself.
- Outcome and homeowner reaction
- Jason's bedroom registers now push like the living room ones. He said the system finishing a heat call without fading is the fix he had been chasing for two winters.
Broomfield sits between two job markets, and owners here compare a lot of quotes. Ours are written, full, and flat: the price we quote is the price you pay. That is why many Broomfield jobs start as second opinions.
Services in Broomfield
AC Installation & Replacement · Heat Pump Installation · Heat Pump Repair — and the rest on the Services page. Local note: systems here are set for altitude, at about 5,300 feet, like every job we run in the metro.
Not your town? See the full Service Areas list.
Request Service in Broomfield
Call (983) 955-0252 or send the form on the Contact page. Tell us the city and what the system is doing, and we will book the right visit.
Our Services in Broomfield, CO
AC Installation & Replacement · AC Repair · Air Duct Cleaning · Air Duct Repair & Replacement · Boiler Installation & Replacement · Boiler Repair · Commercial HVAC Installation & Replacement · Commercial HVAC Repair & Maintenance · Ductless Mini-Split Installation · Ductless Mini-Split Repair · Emergency HVAC Repair · Furnace Installation · Furnace Repair · Heat Pump Installation · Heat Pump Repair · HVAC Maintenance & Tune-Ups · HVAC Replacement · HVAC Zoning System Installation · Indoor Air Quality Services · Thermostat Installation & Replacement
More Areas We Serve
Applewood, CO · Commerce City, CO · Denver, CO · Edgewater, CO · Federal Heights, CO · Golden, CO · Ken Caryl, CO · Lakewood, CO · Morrison, CO · Northglenn, CO · Superior, CO · Thornton, CO · Westminster, CO · Wheat Ridge, CO