Boiler Repair in Arvada, CO
Price: $250–$900. Terms: full price quoted before work; balance due when the job tests right. Time: most fixes done the same day. Repair note: if a repair beats a swap on cost and life, we tell you.
Radiators gone cold point to a short list of boiler faults. We serve Arvada first and the suburbs around it, and we size and set every system for work at about 5,300 feet.
Frequently Asked Questions
Why do my radiators bang?
Banging is often air in the lines or water flashing to steam from scale in the boiler. Both are fixable. Do not ignore it — pressure faults can get worse.
Can a boiler be unsafe?
A boiler with a faulty pressure valve or a cracked exchanger must not run. If the pressure gauge is in the red or you smell gas, shut it down and call.
What will it cost, in the end?
Most boiler repair work lands in the $250–$900 range. You get the exact price after diagnosis and before work starts. The quote is the price — no add-ons at the door.
What Does My HVAC Project Cost?
HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.
HVAC Repair
Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.
AC Installation & Replacement
A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.
Heat Pumps — Repair & Installation
Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.
Ductless Mini-Split Installation
A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.
What Moves the Price
- The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
- Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
- Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
- Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.
Estimate Your Project
The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.
Permit, haul-away, PVC venting on the 96% tier, and altitude setup are in every price.
Priced on existing ducts, matched condenser and coil. New duct runs are priced at the visit.
Dual-fuel keeps your furnace as backup heat — the heat pump carries the year, the furnace takes the coldest nights.
Most single-zone installs are done in one day. Cold-climate units are the standard spec here.
Fall for heating, spring for cooling. A worn part found on the visit is quoted in full before any work starts.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Arvada HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the system. Photos of the nameplate, the furnace cabinet, and the outdoor unit help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 955-0252.
One job, step by step
Denise's boiler announced itself every morning with a bang, and the upstairs radiators stayed cold no matter how long it ran. The circulator pump had seized, leaving the hot water with nowhere to go. A new cast-iron circulator, a full line bleed, and a pressure reset had all nine radiators heating evenly in about three hours.
- Service performed
- Boiler Repair in Arvada.
- Scope of work
- Circulator pump swap, line bleed, and pressure reset.
- Materials / products used
- Cast-iron circulator pump, OEM spec.
- Size
- 120,000 BTU boiler serving 9 radiators.
- Final price
- $610.
- Cost per sq ft
- Not used for repair work.
- Turnaround / duration
- Same day, about 3 hours.
- Payment terms / financing
- Full price quoted before work; balance due when all radiators heat.
- Problem found
- Upstairs radiators stayed cold and the boiler banged at start-up.
- Solution delivered
- New circulator and a full line bleed; every radiator heats evenly now.
- Homeowner first name
- Denise.
- Homeowner city / neighborhood
- Arvada, CO.
- Homeowner situation (in their own terms)
- Upstairs radiators stayed cold and the boiler banged at start-up like it was angry. The bedrooms were colder than the kitchen for weeks.
- Outcome and homeowner reaction
- Hot water moving again meant every radiator in Denise's house heats evenly now. She said the silent start-up the next morning was almost unsettling — in a good way.
Signs You Need Boiler Repair
- Some radiators stay cold.
- Boiler makes banging or kettling sounds.
- Pressure gauge reads low or high.
- Pilot will not stay lit.
What Usually Causes It
- Air trapped in the lines.
- A circulator pump that seized.
- A pressure valve or tank that failed.
- Scale built up in the heat exchanger.
How the Work Goes
- We check pressure, pump, and air in the lines first.
- You get the fault and the full price before work.
- We bleed the lines and test heat at each radiator.
Questions About Boiler Repair
Request Boiler Repair
Prefer to talk? Call (983) 955-0252.
Related services: Boiler Installation & Replacement, Ductless Mini-Split Installation, and Ductless Mini-Split Repair.
Also serving: HVAC Services in Denver, HVAC Services in Edgewater, and HVAC Services in Federal Heights.
Related Services
AC Installation & Replacement · AC Repair · Air Duct Cleaning · Air Duct Repair & Replacement · Boiler Installation & Replacement · Commercial HVAC Installation & Replacement · Commercial HVAC Repair & Maintenance · Ductless Mini-Split Installation · Ductless Mini-Split Repair · Emergency HVAC Repair · Furnace Installation · Furnace Repair · Heat Pump Installation · Heat Pump Repair · HVAC Maintenance & Tune-Ups · HVAC Replacement · HVAC Zoning System Installation · Indoor Air Quality Services · Thermostat Installation & Replacement