Furnace Installation in Arvada, CO
Price: $4,800–$8,500. Terms: full price quoted before work; balance due when the job tests right. Time: most installs done in one day. Repair note: if a repair beats a swap on cost and life, we tell you.
Frequently Asked Questions
How long does a furnace swap take?
Most swaps take one day. The new unit is set, vented, and tested the same day, so you are not left without heat at night.
What size furnace do I need?
Size comes from the home: square feet, windows, insulation, and duct size. A unit that is too big cycles on and off and wears out fast. We do the math on site.
What will it cost, in the end?
Most furnace installation work lands in the $4,800–$8,500 range. You get the exact price after diagnosis and before work starts. The quote is the price — no add-ons at the door.
What Does My HVAC Project Cost?
HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.
HVAC Repair
Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.
AC Installation & Replacement
A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.
Heat Pumps — Repair & Installation
Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.
Ductless Mini-Split Installation
A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.
What Moves the Price
- The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
- Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
- Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
- Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.
Estimate Your Project
The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.
Permit, haul-away, PVC venting on the 96% tier, and altitude setup are in every price.
Priced on existing ducts, matched condenser and coil. New duct runs are priced at the visit.
Dual-fuel keeps your furnace as backup heat — the heat pump carries the year, the furnace takes the coldest nights.
Most single-zone installs are done in one day. Cold-climate units are the standard spec here.
Fall for heating, spring for cooling. A worn part found on the visit is quoted in full before any work starts.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Arvada HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the system. Photos of the nameplate, the furnace cabinet, and the outdoor unit help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 955-0252.

A new furnace sized right for the home and for thin mile-high air. We serve Arvada first and the suburbs around it, and we size and set every system for work at about 5,300 feet.
One job, step by step
Mark's old furnace was oversized for his 2,300 sq ft home — all blast, no patience, and the back rooms paid for it. In one day the 70% unit came out and a 96% two-stage went in, with the vent and gas line brought up to match. Sized off a load check and balanced at the ducts, the house now warms in one long, quiet run instead of a dozen short ones.
- Service performed
- Furnace Installation in Arvada.
- Scope of work
- Old 70% furnace out; new 96% two-stage furnace in, with vent and gas line updates.
- Materials / products used
- 96% AFUE two-stage gas furnace, new filter rack.
- Size
- 90,000 BTU unit for a 2,300 sq ft home.
- Final price
- $6,835.
- Cost per sq ft
- About $2.97 per sq ft of home served.
- Turnaround / duration
- One day.
- Payment terms / financing
- Deposit to book; balance due when the heat is tested and on.
- Problem found
- Old furnace short-cycled and left the back rooms cold.
- Solution delivered
- Right-sized two-stage unit; ducts balanced so back rooms heat evenly.
- Homeowner first name
- Mark.
- Homeowner city / neighborhood
- Arvada, CO.
- Homeowner situation (in their own terms)
- The old unit roared on, cooked the front of the house, and shut off before the back bedrooms got anything. We lived in layers all winter.
- Outcome and homeowner reaction
- The two-stage furnace holds the whole house within a degree, front to back. Mark said the first night it ran low and steady, he checked it twice because he could not hear it working.
Signs You Need Furnace Installation
- Furnace is 15 years old or more.
- Repair bills keep stacking up.
- Some rooms never get warm.
- Gas bills climb each winter.
What Usually Causes It
- Heat exchanger wear that ends a furnace's safe life.
- Old low-efficiency units that waste gas.
- A unit too big or too small for the house.
How the Work Goes
- We size the new unit to the home, not the old nameplate.
- Old unit out, new unit set, vented, and wired in one day.
- We test heat in every room before we leave.
Questions About Furnace Installation
Request Furnace Installation
Prefer to talk? Call (983) 955-0252.
Related services: Furnace Repair, AC Repair, and AC Installation & Replacement.
Also serving: HVAC Services in Denver, HVAC Services in Edgewater, and HVAC Services in Federal Heights.
Related Services
AC Installation & Replacement · AC Repair · Air Duct Cleaning · Air Duct Repair & Replacement · Boiler Installation & Replacement · Boiler Repair · Commercial HVAC Installation & Replacement · Commercial HVAC Repair & Maintenance · Ductless Mini-Split Installation · Ductless Mini-Split Repair · Emergency HVAC Repair · Furnace Repair · Heat Pump Installation · Heat Pump Repair · HVAC Maintenance & Tune-Ups · HVAC Replacement · HVAC Zoning System Installation · Indoor Air Quality Services · Thermostat Installation & Replacement