HVAC Services in Applewood, CO

Arvada HVAC Pros provides heating and cooling services in Applewood, with most repair calls booked the same day.

Wheat Ridge's Applewood area sits along the Clear Creek valley, with older ranch homes and big shade trees. Homes near Crown Hill and the Applewood golf course mix 1960s ranches with newer infill. Many still run the furnace they were built with.

Work here often starts with shade. Big trees keep roofs cool but drop leaves and cotton into outdoor units. We clear the coil, check the charge, and look at the duct runs in the crawl space. Applewood homes reward a crew that works clean in tight, older mechanical spaces.

📞 Talk to an HVAC Specialist: (983) 955-0252

Frequently Asked Questions

How fast can you come out?

Most repair calls are booked the same day. Winter no-heat calls go first.

Do you quote before you start?

Always. You get the fault and the full price before any part goes in. The quote is the price.

What does a repair cost?

Most furnace and AC repairs run $189–$780. Installs are priced per home after a sizing visit. Each service page lists its range.

Do you service boilers and radiators?

Yes. Boiler repair and replacement are core services, and many older homes in the area run radiators.

Can a heat pump work in Colorado winters?

Cold-climate models heat well below zero. Many homes pair a heat pump with a furnace for the coldest nights — that dual-fuel setup is common here.

Do you clean ducts?

Yes — a full brush-and-vacuum clean runs $300–$600 for most homes, priced by vent count before we start.

What Does My HVAC Project Cost?

HVAC work is priced by the job — the fault, the system, the efficiency tier. Here are the ranges we see on real jobs around Arvada, and a calculator built on the same numbers.

HVAC Repair

Most single-fault repairs land $189 to $780 all-in — the diagnostic is folded into the floor of every range here. A wear part (igniter, flame sensor, capacitor, contactor) runs $189 to $400; a blower motor or control board $400 to $780; a refrigerant leak search, seal, and recharge $300 to $780. A failed compressor or heat exchanger is priced at the visit — on an older system that is usually a replace decision, and we show you the math.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed. A 96% AFUE condensing furnace runs $6,500 to $8,500, PVC venting and altitude setup included. Every furnace here is sized off a load check and set for thin air at about 5,300 feet — that work is in the price, not an adder.

AC Installation & Replacement

A standard 14–15 SEER2 central AC runs $5,200 to $7,900 installed on existing ducts. A high-efficiency variable-speed system runs $7,500 to $9,800. New systems use R-454B refrigerant — that is in these numbers, and it is one reason a leaking R-22 system usually prices better as a replacement than a recharge.

Heat Pumps — Repair & Installation

Heat pump repairs run $220 to $850 by fault. A ducted air-source install runs $7,500 to $11,000; a cold-climate dual-fuel system — heat pump with the furnace kept as backup — runs $9,500 to $14,000 and is the setup that holds up on Arvada's coldest nights.

Ductless Mini-Split Installation

A single-zone mini-split runs $3,800 to $6,500 — one room, a garage, a sunroom. A multi-zone job (2–4 rooms on one outdoor unit) runs $6,500 to $12,000. Cold-climate units keep heating on below-zero nights.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 per system — start-up test, flame sensor clean, heat exchanger and safety controls check, and a full run cycle. It is a flat visit price, quoted before we come out.

What Moves the Price

  • The fault. Repairs price by part: a wear part is a $189 to $400 fix, a blower motor or board runs $400 to $780, and a compressor or heat exchanger on an older system is usually the point where replacement wins — we show that math at the visit.
  • Efficiency tier. A 96% furnace costs more than an 80% and burns less gas every winter after. Variable-speed AC runs $7,500 to $9,800 against $5,200 to $7,900 standard — the gap buys quieter, steadier cooling.
  • Altitude setup. At about 5,300 feet, gas pressure, combustion air, and airflow all get set for thin air on every install. It is in every price here — a system set off a sea-level chart is the common local failure.
  • Ducts & access. Install bands assume existing ducts in sound shape. Crushed, leaking, or undersized duct runs are priced at the visit, per run, before work starts.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on altitude. Arvada sits at about 5,300 feet. Every install here is sized off a load check and set for thin air — gas pressure and combustion air on furnaces, airflow and charge on cooling. That setup is figured into every price on this page.

Estimate Your Project

1 · Pick your project

The diagnostic is in every price. If a repair is not worth the cost, we tell you before any work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Projects Completed in Applewood

Furnace Repair — an Applewood job

Walter's Applewood furnace had started to sound like a jet winding up every time the blower kicked on, and by January the heat was cutting out on high limit twice a day. The inducer motor bearings were shot and the wheel was packed with years of dust. A new inducer assembly and a full blower clean had it running quiet the same afternoon.

Service performed
Furnace Repair in Applewood.
Scope of work
Full diagnostic, inducer motor assembly swap, and a blower wheel clean.
Materials / products used
OEM inducer motor assembly and a high-limit switch.
Size
100,000 BTU gas furnace, 2,120 sq ft home.
Final price
$470.
Cost per sq ft
Not used for repair work.
Turnaround / duration
Same day, in just under 2.5 hours.
Payment terms / financing
Price approved on site before the swap; paid in full when the heat cycled clean.
Problem found
Inducer motor bearings failing; blower cut out on high limit twice a day.
Solution delivered
New inducer assembly fitted and the blower wheel cleaned; furnace ran three full cycles without a trip.
Homeowner first name
Walter.
Homeowner city / neighborhood
Applewood, CO.
Homeowner situation (in their own terms)
The furnace sounded like it was taxiing for takeoff, and then it would just quit mid-cycle. The house never stayed warm for long.
Outcome and homeowner reaction
The new inducer is quiet enough that Walter hears the burners instead of the motor. He said the limit trips stopped entirely and the upstairs finally holds temperature overnight.

Furnace Installation — an Applewood job

Rosa's Applewood split-level still ran its original 1980s furnace, an 80,000 BTU unit that burned gas like it was free and left her sewing room over the garage out of the loop entirely. She chose a modern 80% single-stage sized off a load check for her 1,720 sq ft, and the crew swapped it in a day, filter rack included.

Service performed
Furnace Installation in Applewood.
Scope of work
Original 80% furnace out; new 80% single-stage furnace in with a new filter rack and vent check.
Materials / products used
80% AFUE single-stage gas furnace, new filter rack.
Size
80,000 BTU unit for a 1,720 sq ft home.
Final price
$5,940.
Cost per sq ft
About $3.45 per sq ft of home served.
Turnaround / duration
One day.
Payment terms / financing
Half down to hold the install date; the rest due after the first full heat run.
Problem found
Original 1980s furnace burned excess gas and never heated the room over the garage.
Solution delivered
Right-sized 80% unit set for altitude; the over-garage room now heats with the rest of the home.
Homeowner first name
Rosa.
Homeowner city / neighborhood
Applewood, CO.
Homeowner situation (in their own terms)
That furnace was older than my kids and the sewing room was a freezer with a door. I wanted simple and reliable, not fancy.
Outcome and homeowner reaction
Rosa's gas use dropped in the first month and the sewing room holds within a degree of the hallway. She said she has stopped sewing in a coat.

AC Repair — an Applewood job

Greg's Applewood condenser was cooling fine until it was not — the house crept to 81 on a Saturday while the unit ran nonstop and the suction line stayed warm. A leak search found refrigerant escaping at a cracked flare on the liquid line. The flare was re-made, the line sealed, and the charge weighed back in for altitude.

Service performed
AC Repair in Applewood.
Scope of work
Refrigerant leak search, liquid-line flare re-made and sealed, and a full recharge by weight.
Materials / products used
R-410A refrigerant and a new brass flare nut.
Size
2.5-ton condenser, 1,640 sq ft home.
Final price
$615.
Cost per sq ft
Not used for repair work.
Turnaround / duration
Same day, about 3 hours.
Payment terms / financing
Quoted in full after the leak search; balance settled once the vents blew cold again.
Problem found
Refrigerant leaked at a cracked liquid-line flare; the system ran nonstop and the house hit 81.
Solution delivered
Flare re-made and sealed, charge weighed back in; supply air measured 18 degrees below room temp.
Homeowner first name
Greg.
Homeowner city / neighborhood
Applewood, CO.
Homeowner situation (in their own terms)
The AC ran all day and lost. When the line is warm to the touch in July, you know the cold went somewhere it should not.
Outcome and homeowner reaction
Greg's house pulled down to 74 before the crew packed up. He said the unit cycling off at noon, instead of grinding until dark, told him the charge was right.

One more Applewood note: many homes here have finished basements fed by long, low duct runs. If the basement is cold while the main floor is fine, the fix is usually air balance, not a bigger furnace. We test before we sell.

Services in Applewood

Furnace Repair · Furnace Installation · AC Repair — and the rest on the Services page. Local note: systems here are set for altitude, at about 5,300 feet, like every job we run in the metro.

Not your town? See the full Service Areas list.

Request Service in Applewood

Call (983) 955-0252 or send the form on the Contact page. Tell us the city and what the system is doing, and we will book the right visit.

📞 (983) 955-0252